Mitsubishi XD400U User Manual download pdf

1) Interface

Controling the projector using a personal computer

This projector can be controlled by connecting a personal computer with RS-232C terminal.

PC-controllable functions :

• Turning the power ON or OFF

• Changing input signals

• Inputting commands by pressing the buttons on the control panel and remote control

• Menu setting

Connection

SERIAL

to RS-232C

terminal

RS-232C cable

D-SUB 9-pin

8-pin

Important:

• Make sure that your computer and projector are turned off before connection.

• Boot up the computer first, and then plug the power cord of the projector.

(If you do not follow this instruction, the Comport may not function.)

• Adapters may be necessary depending on the PC connected to this projector. Contact your dealer for details.

PROTOCOL RS-232C

BAUD RATE 9600 [bps]

DATA LENGTH 8 [bits]

PARITY BIT NONE

STOP BIT 1 [bit]

FLOW CONTROL NONE

This projector uses RXD, TXD and GND lines for RS-232C control.

For RS-232C cable,the reverse type cable should be used.

2) Control command diagram

The command consists of the address code, function code, data code, and end code. The length of the command

varies among the functions.

Address code Function code Data code End code

HEX 30h 30h Function Data 0Dh

ASCII '0' '0' Function Data

[Address code] 30h 30h (In ASCII code, '0' '0') fixed.

[Function code] A code of each fixed control move.

[Data code] A code of each fixed control data (number) and not always indicated.

[End code] 0Dh (In ASCII code, ' ') fixed.

Data Projector

XD480U / XD450U / XD400U

1 2 3 4 5

Summary of Contents

Page 1 - XD480U / XD450U / XD400U

11) InterfaceControling the projector using a personal computerThis projector can be controlled by connecting a personal computer with RS-232C termina

Page 2 - 3) Control sequence

23) Control sequence(1) Send the command from the personal computer to the projector.(2) The projector will send a return command after it receives an

Page 3 - 9) Password lock commands

3Sending commands Status code from Descriptionfrom the PC, etc. the projector30 30 72 35 34 0D Command operating the same'0' '0' &

Page 4 - ) Reading command diagram

411) Menu setting commands (Not executable in stand-by mode. Possible only to read during muting.)The menu setting commands are used for the menu se

Page 5

5How to set the gradeUse the ASCII codes to set the grade for setting data. Please refer to the table below for the HEX code.ASCII '+' &apos

Mitsubishi XD400U User Manual

Browse online or download User Manual for Data projectors Mitsubishi XD400U. Mitsubishi XD400U User manual

Summary of Contents

More documents for Data projectors Mitsubishi XD400U

Comments to this Manuals

Mitsubishi XD400U User Manual

Browse online or download User Manual for Data projectors Mitsubishi XD400U. Mitsubishi XD400U User manual

Summary of Contents

More documents for Data projectors Mitsubishi XD400U

Comments to this Manuals

Related products and manuals for Data projectors Mitsubishi XD400U