Mitsubishi UNISEN 164 SERIES Operations Instructions download pdf (Page 23)

3. TV Features 23

For assistance call 1(800) 332-2119

Microphone Placement

Be sure the

height of the

microphone is

within three feet

of the speaker

height.

Center the micro-

phone in front of

the TV.

Set the microphone

on a level surface at

ear height at least

six feet from the TV.

Use a seat backrest

or tripod so as to

pick up sound from

all directions.

Maximum height above speakers

Microphone

6 ft. minimum

Microphone

Height of TV

speakers

3 ft.

Sound Projector, continued

Adjusting Beam Angles

a. Adjust Center Beam Angle until sound is

about equal in both ears.

b. Adjust Left Beam Angle to maximize sound

heard from the front left side.

c. Adjust Right Beam Angle to maximize sound

heard from the front right side.

d. Adjust Left Surround Beam Angle to where

the sound seems to come from the left rear

side. If this cannot be achieved, make the

setting the same as that for Left Beam Angle.

e. Adjust Right Surround Beam Angle to where

the sound seems to come from the right rear

side. If this cannot be achieved, make the

setting the same as that for Right Beam Angle.

Adjusting Levels

a. Adjust Center Level to the mid level.

b. Adjust the following levels one at a time so that

each one sounds about the same as the center

level:

Left Level

Right Level

Left Surround Level

Right Surround Level

c. Check all sound levels by quickly switching

between them using .

d. Readjust individual levels in small increments

and recheck as above until all sound levels

seem about the same.

Resetting Angle and Level Values in the

Custom Menu

Press

EXIT

to clear all menus.

Press

MENU.

Go to the Sound > SoundPro menu

and press

ENTER

Change any setting (e.g.,

TV Location).

Press

EXIT

to clear all menus.

Press

MENU.

Go to the Sound > SoundPro menu

and press

ENTER

Enter the correct values for the room layout.

Return to the

CUSTOM menu to adjust angles and

levels.

Auto Setup

265 Series

This section describes auto-setup available with 265 series

TVs.

Auto setup uses the included calibration micro-

phone.

Power on the TV and external subwoofer, if any.

Plug the microphone cable into the TV’s

2. INPUT 2

left audio jack.

Place the microphone as described in the guide-

lines.

Press

and go to Sound > AutoSP.

Highlight

START and press

ENTER

Quietly exit the room right away.

6. Wait for completion

of setup before returning to the room.

Play some sample audio material to check the

sound quality.

Note: Do not perform manual adjustments after run-

ning Auto setup.

Store the microphone out of direct sunlight and

away from heat.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Comments to this Manuals

No comments

Mitsubishi UNISEN 164 SERIES Operations Instructions Page 23

Comments to this Manuals

Related products and manuals for LCD TVs Mitsubishi UNISEN 164 SERIES