Mitsubishi Accessport User's Guide download pdf (Page 10)

Accessport Installation Page 10

b) (Accessport Version 2b only):

• Plug the OBD-II cable into the OBD-II port

under the dash.

• Connect the other end of the OBD-II cable

to the 10-pin port on the bottom of the

Accessport. At this point the Accessport

will power up and after a few moments

present the installation menu.

4. Plug the large end of the USB cable into the standard USB port on the underside of

your Accessport. At this point the Accessport will power up and present the

installation menu after approximately 20-30 seconds.

5. Select [Install] from the Accessport menu by pressing the [OK] button to proceed

with installation. The ignition key must be in the ON position. Below is a diagram of

the Accessport's keypad function.

Revision 1.097 Jun 25, 2013

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

No comments

Mitsubishi Accessport User's Guide Page 10