145
Figure 13-2 Diagnostic connectors for most 1987 and earlier vehicles
A—3-pin connector
B—9-pin connector
C—2-pin connector
D—Green (preferable) or Yellow
E—Engine: Green (preferable) or Yellow
F— Transmission: Green or Yellow
G—Black
z To read engine and transmission codes from most 1988 and later OBD-I vehicles:
• Use the HYUN-2 adapter (Figure 13-3).
Figure 13-3 Connector and adapter for SRS system on most 1994 and earlier vehicles
A—HYUN-2 adapter
B—Connector
z To read codes from OBD-II vehicles with 12 and 16-pin connectors:
• Use the MITSU-1 adapter with the OBD-II adapter attached (Figure 13-4 on page 146).
Table 13-2 Mitsubishi diagnostic connector locations for most 1987 and earlier vehicles
CONNECTOR INSTRUCTIONS
3-PIN
Right front fender, near head lamp. Use MULTI-1 adapter and connect colored
leads as shown.
9-PIN
In glovebox, next to latch. Use MULTI-1 adapter and connect colored leads as
shown, using black terminal converters.
2-PIN
Use MULTI-1 adapter and connect colored leads as shown, using white
terminal converters.
AB C
D
D
E
F
G
G
G
AB
Comments to this Manuals