Mitsubishi VS-4542 Operations Instructions download pdf (Page 32)

Projection TV + VCR + antenna or cable without a

decoder box (cont.)

_Important:

procedure

O Connect the incoming (',able or antenna to the ANTENNA IN

terminal on the VCR.

O Connect; one end of a coaxial cable to the ANTENNA OUT

terminal on the VCR.

Connect the other end of the cable to the ANT-A terminal on

the Projection TV.

Connect an RCA pin-type video cable to the VIDE{) OUT

terminal on the back of the VCR. Connect the other end of this

cable to the VIDEO INPUT terminal on the back c,f the televi-

sion.

If you are connecting a Super VHS (S-VHS) VCR, use a Super

Video cable instead of an RCA pin-type video cable. Connect a

Super Video cable to the S.-VIDEO OUT terminal on the VCR.

Connect the other end of this cable to the S-VIDEO INPUT termi-

nal on the back of the Projection TV.

Connect a set of RCA pin-type audio cables to the .AUDIO OUT

terminals on the back ,of the VCR. Use the red cable to connect

the right (R) channel and the white cable for connecting the left

(L) channel.

Connect the other ends of this cable to the AUDIO INPUT

terminals on the back of the Projection TV.

If your VCR is monaural (non-stereo), you only need to connect a

single RCA pin-type audio cable. Connect the cable to the VCR,

then connect the other end to the L (LEF] _) audio input on the back

of the Projection TV.

If your VCR has a video channel switch, ,_et it to "OFF/AV." See

your VCR's owner's guide for details.

Start playing a tape on youc VCR.

Use the INPUT button on your Projection TV's remote control

to select the correct input. If you connected the VCR to EXT-1,

select EXT-1; if you connected the VCR to EXT-2, select EXT-2.

32 Chapter 2: Connecting Your Projection TV

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 99 100

No comments

Mitsubishi VS-4542 Operations Instructions Page 32