EN-1LAN Control Utility User Manual (for FL7000U/FL7000LU)ContentsPreparation/SetUp ...
EN-101Enter “3” and press the Enter key. 2To enable the e-mail notification function of Projector-View, enter 1 and press the Enter key. (Default is OF
EN-111Enter “9” and press the Enter key. 2The setting screen is shaded and the setting is updated.• It takes about 10 seconds for the setting to be u
EN-121Start the Projector-Control Device Installer.• Select [Start] - [All Programs] - [Projector] - [Projector-Control Device Installer] (i
EN-135The password input screen appears. Enter the password you set. • The default password is admin.(Note)If you input a wrong password 4
EN-14ProjectorView (continued)VIRTUAL REMOTE controllerPut a checkmark in the box of the Virtual remote enabled on the ProjectorView main screen, and
EN-15Initial settingTo load information on the projector such as model name and lamp operating time, set the projector data in advance.
EN-16Support for the PJLink™ function This projector supports standard protocol PJLink™ for projector control and you can control and monitor projecto
EN-17[Notes on Instant Shut Down]Instant shutdown of the projector during control using the network function may cause ProjectorView to
EN-2Preparation/SetUpPreparation before using the network functionThis projector is equipped with the network function to control and monitor the proj
EN-31Copy three files (DI_4.1.3.4.msi, Setup.Exe, and Setup.Ini) contained in the Tools folder of CD-ROM to the hard disk of your personal computer.2Do
EN-4Preparation/SetUp (continued)4Select a folder to install the program, and click Next. 5Click Next. 6Installation starts.• The progress of the
EN-51Start the Projector-Control Device Installer.• Select [Start] - [All Programs] - [Projector] - [Projector-Control Device Installer] (in
EN-65Select [Obtain an IP address automatically] and click Next. 6Click Next.• Check that the options are marked with check-marks as shown on the rig
EN-75Select [Assign a specific IP address] and click Next. 6Enter a fixed IP address (for example, 192.168.0.1) and click Next. (Note)Do not use 0 o
EN-81Start the Projector-Control Device Installer.• Select [Start] - [All Programs] - [Projector] - [Projector-Control Device Installer] (in
EN-91Enter “0” and press the Enter key. 2Input the old (current) password and press the Enter key. (Default password is admin.)• If you input a wrong
Comments to this Manuals