Mitsubishi PJLink FD630U User Manual download pdf (Page 24)

EN-24

8. Web UI

 Web UI Info screen

Whenyouclick[Info]onthecontrolscreen,thefollowingscreenwillappear.Thisscreenshowstheinformation

andstatusofthecurrentlyconnectedprojector.Youcangobacktothecontrolscreenbyclicking[Exit].





 Projector Information

The following information of the projector is displayed.

Projector Name: Shows the projector’s name.

Location: Shows the name of the location where the projector is installed.

Mac Address: Shows the MAC address.

Resolution: Shows the resolution of the video signal being projected.

Lamp Time: Shows the lamp operation time as converted into that in the Low lamp mode.

<Note>

• Whentheprojector’slampmodeissettoStandard,thelampoperationtime

shown on this screen may be longer than the actual lamp operation time.

Projector Model: Shows the projector’s model name.

 Projector Status

The following information on the projector’s status is displayed.

Power Status: Shows the projector’s power status.

Input Source: Shows the name of the source currently selected.

Lamp Mode: Shows the lamp mode currently selected.

Error Status: Shows the following information if an error occurs in the projector.

Message in the [Error Status] box Error description

3:FanError The fan has an error.

3:LampStrikeFailure The lamp has failed to illuminate.

1:Lampreplacementrecommended The lamp life has ended.

3:Lampreplacementrequired The lamp life will end soon.

3:ProjectorOverheating The projector is overheated.

2:TemperatureWarning The projector is about to be overheated.

3:LampCoverOpened The lamp cover is open.

4:AbnormalStateDetected The projector has an error.

<Note>

• Whentheprojectorisinthenormalstatus,the[ErrorStatus]boxisblank.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30

No comments

Mitsubishi PJLink FD630U User Manual Page 24