Mitsubishi PAR-U02MEDA Installation Manual

CITY MULTI Control SystemSmart ME Controller PAR-U02MEDAInstallation ManualPrior to use, thoroughly read the instructions in this manual to use the pr

– 9 –• Cut out the thin-wall part on the cover (indicated with the shaded area in the right figure) with a knife or a nipper. Note:Make sure that the

– 10 –6 Connect the remote controller cable to the terminal block on the top case.Connect the remote controller cable to the terminal block. * Take t

– 11 –7 Set the M-NET addresses.* The factory setting for the rotary switches is 01.** M-NET address can be changed with or without the power being ap

– 12 – Direct wall installation (when running the cable along the wall)• Thread the cable through the access hole at the top of the remote controlle

– 13 – Discrepancy between the room temperature measured at the wall and the actual room temperature may occur.If the following conditions are met, t

– 14 –Chapter 2. Initial SettingThis chapter contains information about the settings to be made at the time of installation. Please read the instructi

– 15 –(2) Setup screenAfter completing the settings, touch the [Back] button on the [Setup] screen. The message “Collecting the information from the a

– 16 –A password is required to access the Menu (Service) screen or some settings under the Menu (User) screen.• The initial Service password is “9999

– 17 –*1 This setting will not become effective if the temperature sensor on the indoor unit is activated.*2 The LED indicates the operation status of

– 18 –(1) Setup menu(a) Group settingRefer to section 1 "Initial Settings" (2) "Setup screen". (b) LOSSNAY interlockRefer to secti

– 1 –Chapter 1. InstallationThis installation manual describes how to install the Smart ME Controller for use with Mitsubishi Building Air Conditionin

– 19 –(h) Telephone number (i) IC function setting1Select the indoor unit address in the [M-NET address] field. (When [Grp] has been selected, all the

– 20 –(k) Reset RC (l) AHC port name(2) Error Menu (a) Self check(max. 20 characters)WT06829X02.book Page 20 Wednesday, June 26, 2013 4:03 PM

– 21 –(a) Read the section about Test run in the indoor unit Installation Manual before performing a test run.(b) During the test run, indoor units wi

– 22 –*1 Not for use with a generic DC power supply device.*2 “Power consumption coefficient” is a coefficient to calculate the relative power consump

Please be sure to put the contact address/telephone number on this manual before handing it to the customer.This product is designed and intended for

– 2 – CAUTION WARNING CAUTION WARNING CAUTIONPrecautions during installationPrecautions during wiringTo reduce the risk of fire or explosion, do not p

– 3 – WARNING CAUTIONThe CD-ROM that is supplied with Smart ME ControllerThe CD-ROM that is supplied with the Smart ME Controller contains an Installa

– 4 –The following parts are included in the box.(1) Field-supplied parts(2) Required tools• Flat-tip screwdriver (Width: 4-5.5 mm (5/32-7/32 in))• Kn

– 5 –*1 The power consumption coefticient of the Smart ME Controller is “0.5” and that of a ME Remote Controller (PAR-F27MEA) is “0.25”.If the number

– 6 –This remote controller is for the wall installation. It can be installed either in the switch box or directly on the wall. When performing direct

– 7 –Occupancy sensor detects occupancy based on the temperature difference between the occupant and its surroundings.To be precise, to enhance the se

– 8 –(2) Installation spaceLeave a space around the remote controller as shown in the figure below, regardless of whether the controller is installed