Mitsubishi City Multi PKFY-P.VBM-E Service Manual download pdf (Page 30)

5. REMOVING THE NOZZLE ASSEMBLY AND DRAIN HOSE

(1) Remove the front panel (Refer to procedure 2).

(2) Remove the electrical box cover. (See Photo 2)

(3) Disconnect the connector (CN5V) on the indoor controller

board.

(4) After unhook the right side of the corner box, press the

upper left side and remove the corner box.

(5) Remove the nozzle assembly from the fixture.

(See Photo 5)

(6) Remove the drain hose.

Photo 5

Heat exchanger

Electrical box

Fixture

Drain hose

6. REMOVING THE LINE FLOW FAN AND THE FAN MOTOR

(1) Remove the front panel. (Refer to procedure 2)

(2) Remove the nozzle assembly. (Refer to procedure 5)

(3) Remove the electrical parts box. (Refer to procedure 4)

(4) Remove the fixture while pressing the right side of motor

fixture catch. (See Photo 6)

(5) Remove the left side of the motor fixture.

(6) Loosen the screw which fixes the line flow fan to the fan

motor, then remove the fan motor by sliding it to the right

side. (See Photo 6)

(7) Pull the left-hand side of the heat exchanger toward you.

(See Photo 7)

(8) Remove the line flow fan.

Photo 6

Heat exchanger

Fan motor

Photo 7

Heat exchanger

7. REMOVING THE VANE MOTOR

(1) Remove the front panel. (Refer to procedure 2)

(2) Remove the screw of the electrical parts box cover, and

remove the cover.

(3) Remove the 2 screws of the vane motor. (See Photo 8)

Disconnect the relay connector and remove the motor

from the shaft.

(4) Disconnect the vane motor connector (CN5V) on the

indoor controller board.

Photo 8

Heat exchanger

Vane motor

Nozzle assembly

8. REMOVING THE LIQUID PIPE THERMISTOR AND GAS

PIPE THERMISTOR

(1) Remove the front panel. (Refer to procedure 2)

(2) Remove the electrical box cover. (See Photo 2)

(3) Remove the water cut. (See Photo 3)

(4) Cut the wiring fixed band.

(5) Remove the liquid pipe thermistor and gas pipe thermistor.

(See Photo 9)

(6) Disconnect the connector (CN29) (CN21) on the indoor

controller board.

Photo 9

Heat exchanger

Drain hose

Fixture set screws

Set screws

Drain hose

Nozzle assembly

Fixture (left)

Nozzle assembly

Fixture

Line flow fan

Heat exchanger

fixture (left)

Vane motor fixing

screws

Gas pipe

thermistor

Liquid pipe thermistor

Electrical box

Fixture (right)

PHOTOS & ILLUSTRATIONSOPERATION PROCEDURE

OCH418C

1 2 ... 25 26 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments

Mitsubishi City Multi PKFY-P.VBM-E Service Manual Page 30

Comments to this Manuals

Related products and manuals for Split-system air conditioners Mitsubishi City Multi PKFY-P.VBM-E