Mitsubishi XD20A User Manual download pdf (Page 15)

E – 15

Adjuster Adjustment

There are two adjusters: one on the right side of the back panel

and another in the front center of the main unit.

To raise the projection position:

1Use right hands to lift the front of the main unit to approxi-

mately the desired adjustment angle.

2Press the adjuster button on the front.

Loosen the adjuster legs and allow them to drop into position.

3Release the button.

The extended adjuster legs will be locked.

4Rotate the contact surfaces of the rear adjuster either clock-

wise or counterclockwise to accurately adjust the level.

To lower the projection position:

Preparation: Lower the front adjuster.

1Raise the adjusting foot. If the image is too low, raise the

front adjuster to move up it.

2Rotate the contact surfaces of the rear adjuster either clock-

wise or counterclockwise to accurately adjust the level.

RGB / YCbCr

S VIDEO

VIDEO

MOUSE

6 When distortion of the projected image

cannot be corrected with the adjusters,

press the KEYSTONE +/– buttons of the

remote control to fine adjust (see page

18).

Using KEYSTONE to adjust projected image

distortion.

ZOOM VOLUMEKEYSTONE

Note

Maximum correction is 14 degrees (including optical correc-

tion).

The top and bottom of the projected image is

corrected, as shown below.

If a menu is being displayed, distortion of the

menu will not be corrected.

7 Adjust the image size to match the distance to the screen.

Use the zoom ring to adjust the image size. Next, use the

focus ring to adjust the focus.

OPEN

8 Change the unit setting to suit the

method and source selected in step 4.

•Select the “PROJECTION” appropriate

for the type of projector installation.

(See page 29)

If the image is projected reversed, vertically, or

horizontally, reset “PROJECTION”.

• In the case of video or S-video, select

the color system as necessary. (See

page 26)

Normally, it is not necessary to change the

factory settings. Also, set the RGB/YCbCr con-

nector for component video (YCbCr). (See

page 27)

•In the case of RGB input, adjust the

video of the connected PC.

This projector automatically identifies the input

signal and selects the most appropriate resolution.

However, manually adjust the “PICTURE ADJ”

and “FINE PICTURE” (see page 24) when there

is flicker, noise, color offset, etc., and manually

adjust the vertical and horizontal position (see

page 24) when the image is not centered.

You can also choose to project the image at the

original size of the incoming signal resolution.

(see page 27). (Normally, the resolution is au-

tomatically sensed and the display is enlarged

or reduced.)

Down

(Continued on the next page.)

Down

Focus ring

Zoom ring

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 34 35

Comments to this Manuals

No comments

Mitsubishi XD20A User Manual Page 15

Comments to this Manuals

Related products and manuals for Data projectors Mitsubishi XD20A