Contents1. Safety Precautions...12. Parts List ...
- 9 -2-2. Embedding the centralized controller in the wall.1 Ensure there is enough space to install the controller as shown in the figure at right.2
- 10 -2-3. Wall-mounting the centralized controller.1 Ensure there is enough space to install the controller as shown in the figure at right.2 Punch o
- 11 -2-4. Installing the centralized controller and a power supply unit (PAC-SC51KUA; sold separately) inside the mounting attachment on the wall1 En
- 12 -9 Install the centralized controller inside the mounting attachment with the four M4 screws (supplied).0 Replace the surface cover.a Attach the
- 13 -2 Installing the AG-150A by following the installation method described in 2-4 in 6 Installation , DC power line and M-NET transmission cable ar
- 14 -• Before performing a test run, verify that the group setting has been performed and the startup sequence for the interlocked operation setting
- 15 -(3) External input specifications(A) For level signal1 When the emergency stop/normal signal is selected, the status will switch from normal to
- 16 -(3) Recommended circuit1 Each element will turn on while in ON operation or if a malfunction occurs.2 The connection cable can be extended up to
- 17 -12 Optional accessoriesParts Model Usage NotePower supply unit PAC-SC51KUASupplies power to the controller and M-NET transmission cableElectric
- 1 -This manual describes how to install the centralized controller and wiring. Before installing the controller, read the 1 Safety Precautions s
HEAD OFFICE: TOKYO BLDG. , 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPANAuthorized representative in EU: MITSUBISHI ELECTRIC EUROPE B.V.HARMAN
- 2 -* The Installation Manual and the parts listed below are included with the unit.* If the enclosed screw for attaching the installation plate cann
- 3 -AG-150A is a centralized controller that features advanced functions such as the Web function. Up to 50 indoor units can be monitored and operate
- 4 -NOTE* M-NET terminal (A, B, S) and CN1 cannot be used simultaneously.* Power supply terminal block (V+, V-, FG) and CN2 cannot be used simultaneo
- 5 -* Address setting for each M-NET device (Addresses cannot be duplicated).5 System DiagramAddress setting method AddressIndoor unitSet the indoor
- 6 -1. Field-supplied Parts1 Electric box: PAC-YG83UTB (sold separately) (When following installation method described in section “2. Installation” i
- 7 -2-1. Wall-Embedded installation with an electric box1 Ensure there is enough space to install the controller as shown below. Wall space and 60 mm
- 8 -6 Securely seal the cable lead-in port with putty to prevent dew, water and insects, etc. from earthing.* Seal the space between the electric box
Comments to this Manuals