Mitsubishi Mr.Slim MSZ-FE12NA Service Manual download pdf (Page 31)

MSZ-FE09NA MSZ-FE12NA

NOTE:Turn OFF power supply before disassembling.

OPERATING PROCEDURE

PHOTOS

1. Removing the panel

(1) Hold both sides of the front panel and lift the front panel

until it is level. Pull the hinges forward to remove the front

panel.

(2) Remove the horizontal vanes.

(3) Remove the screw caps of the panel. Remove the screws.

(See Photo 1.)

(4) Unhook the lower part ( ) of the panel.

(5) Hold the lower part of both ends of the panel and pull it

slightly toward you, and then remove the panel by pushing

it upward.

DISASSEMBLY INSTRUCTIONS

(1) Slide the sleeve and check if there is a locking lever or not.

(2) The terminal with this connector has the

locking mechanism.

Slide the sleeve.

Pull the terminal while

pushing the locking

lever.

Hold the sleeve, and

pull out the terminal

slowly.

Connector

Sleeve

Locking lever

Photo 1

Screws of the panel

Front panel

Horizontal vane

<"Terminal with locking mechanism" Detaching points>

The terminal which has the locking mechanism can be detached as shown below.

There are two types (refer to (1) and (2)) of the terminal with locking mechanism.

The terminal without locking mechanism can be detached by pulling it out.

Check the shape of the terminal before detaching.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

No comments

Mitsubishi Mr.Slim MSZ-FE12NA Service Manual Page 31