Graphic Operation Terminal GOT-F900 Key Pad (F920GOT-K and F930GOT-K) 17
17-4
17.2 Handling of ten-keys, cursor control keys, "SET" key, "DEV" key, "ESC" key and
"ENT" key
In the F920GOT-K and the F930GOT-K, values in "suuchi nyuuryoku?" and "asukii
nyuuryoku?" (0 to 9) can be changed using the ten-keys, the cursor control keys, the "SET"
key, the "ESC" key and the "ENT" key.
(The "DEV" key is not used in the data input operation.)
Ten-keys . . . . . . . . . . "0" to "9", "
–
" and "
•
"
Used for entering a numeric value in the data input operation.
Cursor control keys . . "
"
", "
#
", "
!
" and "
$
"
Used for moving the cursor in the data input operation.
"SET" key. . . . . . . . . . Used for displaying the cursor in the data input operation.
"ESC" key . . . . . . . . . Used for canceling the data input operation.
"ENT" key . . . . . . . . . Used for determining the input numeric value in the data input
operation.
• If any character other than "0" to "9", "
–
" and "
•
" is required to be entered as "Ascii Input" in
the F930GOT-K, enter it from the key window. (Refer to Section 7.6.3).
• In the F920GOT-K, any character other than "0" to "9", "
–
" and "
•
" cannot be entered.
• When entering hexadecimal numbers in the F920GOT-K, switch from decimal input mode
to HEX input mode by pressing the "
•
" key.
In the HEX input mode (when HEX is displayed on the right on the screen), "A", "B", "C"
···
and “F” are entered when "1", "2", "3"
···
and “6” keys are pressed respectively.
• When changing data using the GT Designer, the display pattern and movement of the
cursor varies depending on the setting in the screen creation software.
Perform the settings in "Screen" and "Project" available by selection of "Common"
→
"Auxiliary Setting" from the menu bar in the screen creation software. (For the details, refer
to Section 7.)
<Displa
in
the cursor>
This ke
enables data
chan
e.
The cursor is displa
ed
in a tar
et ob
ect
located in the upper left
position on the displa
unit.
<Cancelin
the data chan
e operation>
This ke
cancels the data chan
e
operation.
The previous numeric value before
chan
e is displa
ed once a
ain.
<Determinin
the
numeric value>
This ke
determines
the input numeric
value and writes it to
the PLC.
<Selectin
a tar
et ob
ect>
The cursor control ke
s
allow selection of a tar
et
ob
ect whose data is to be
chan
ed.
<Enterin
a numeric value>
The ten-ke
s allows to input
a numeric value.
SET
" # ! $
0 9
ESC
ENT
Returns to initial
condition.
F930GOT-K
F920GOT-K,
F930GOT-K
Comments to this Manuals