Mitsubishi 4G6 series Specifications download pdf (Page 105)

ENGINE <4D6> -

Engine Assembly

11C-35

REMOVAL SERVICE POINTS

POWER STEERING OIL PUMP AND BRACKET

ASSEMBLY REMOVAL

Remove the power steering oil pump and bracket assembly

from the engine with the hose attached.

NOTE

Place the removed power steering oil pump in a place where

it will not be a hindrance when removing and installing the

engine assembly, and tie it with a cord.

A/C COMPRESSOR REMOVAL

Disconnect the A/C compressor connector and remove the

compressor from the compressor bracket with the hose still

attached.

NOTE

Place the removed A/C compressor where it will not be a

hindrance when removing and installing the engine assembly,

and tie it with a cord.

TRANSMISSION ASSEMBLY REMOVAL

<M/T>:

Refer to GROUP 22.

Caution

Do not remove the flywheel mounting bolt shown by the

arrow. If this bolt Is removed, the flywheel will become

out of balance and damaged.

<A/T>:

Refer to GROUP 23.

ENGINE MOUNT BRACKET REMOVAL

1. Support the engine with a garage jack.

2. Remove the special tool which was attached when the

transmission assembly was removed.

3. Hold the engine assembly with a chain block or similar

tool.

4. Place a garage jack against the engine oil pan with a

piece of wood in between, jack up the engine so that

the weight of the engine is no longer being applied to

the engine mount bracket, and then remove the engine

mount bracket.

ENGINE ASSEMBLY REMOVAL

After checking that all cables, hoses and harness connectors,

etc., are disconnected from the engine, lift the chain block

slowly to remove the engine assembly upward from the engine

compartment.

<M/T>

Flywheel

Bolt

MZ203827

MB991453

1 2 ... 100 101 102 103 104 105 106

Comments to this Manuals

No comments

Mitsubishi 4G6 series Specifications Page 105

Comments to this Manuals

Related products and manuals for Engine Mitsubishi 4G6 series