Mitsubishi 4G6 series Specifications download pdf (Page 53)

ENGINE <6A1> -

Camshaft and Camshaft Oil Seal

11B-17

CAMSHAFT SPROCKET REMOVAL

ROCKER ARM AND SHAFT ASSEMBLY

REMOVAL

1. Install the special tools as shown in the illustration so

that the lash adjusters will not fall out.

2. Loosen the rocker arm and shaft assembly mounting bolt,

and then remove the rocker arm and shaft assembly with

the bolt still attached.

Caution

Never disassemble the rocker arm and shaft

assembly.

INSTALLATION SERVICE POINTS

CAMSHAFT INSTALLATION

Set the camshaft dowel pins so that they are in the position

shown in the illustration.

Caution

Do not mistake the camshafts for the front bank and the

rear bank. The camshaft for the rear bank has a slit with

a width of approximately 4 mm on its rear end.

CAMSHAFT OIL SEAL INSTALLATION

1. Apply engine oil to the camshaft oil seal lip.

2. Use the special tool to press-fit the camshaft oil seal.

MB990767

MD998715

MD998443

Approx.

Dowel

MD998713

MD991559

MD998713

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 105 106

No comments

Mitsubishi 4G6 series Specifications Page 53