Mitsubishi S490 User Manual download pdf (Page 14)

EN – 14

AUDIO 15

To operate projector power ON (Continue)

Turning off the projector

9. Press the POWER button.

The message “POWER OFF? YES : PRESS AGAIN”

appears on the screen.

• To exit from this mode, press any button except

the POWER button. (Some buttons on the remote

control do not work for exit from this mode.)

10.Press the POWER button again.

The light source lamp will be turned off.

Pressing the POWER button second time will shut

off the light source lamp, but the exhaust fan con-

tinues to operate for 120 seconds to cool down the

light source lamp and LCD panels. In this time, the

lamp indicator will be turned off.

11.Turn off the main power switch. When turning off

the main switch, the POWER indicator turns off.

• In cases where the main power switch is acciden-

tally turned off when either the intake/exhaust

fan or the power source lamp is in operation, allow

the unit to cool down for 10 minutes with the

power turned off. Repeat step 3 when turning on

the power source lamp. If the lamp does not turn

on immediately, repeat this step two or three

times. Replace the lamp if it should still fail to

turn on.

AUTO POSITION button

When the source is selected to COMPUTER and the

image is not in the right place, follow as shown below.

1. Set screen to the brightest display as possible

(e.g., full-screen display of the “Trash” window).

2. If the screen saver is running, turn off the screen saver.

3. Press the AUTO POSITION button.

• If the image is still not in the right place, adjust

the image position by using the SIGNAL menu.

The volume from the speaker

Press the volume + or – button to change the volume

from the speaker.

The volume control bar will appear on the screen.

• The volume control bar will disappear about 10

seconds after releasing the volume buttons.

• The volume buttons do not work when MENU

selection bar or MENU is displayed.

• If the high level of audio signal, for example DVD

is supplied into COMPUTER AUDIO IN terminal,

the speaker out may be distorted.

AV mute

Image and audio are temporarily muted by pressing

the MUTE button. To restore the image and audio to

the normal mode, press the MUTE button again.

• The audio from the AUDIO OUT jack is also muted

by pressing the MUTE button.

Caution:

• When you have finished using this equipment, wait

120 seconds for the exhaust fans to stop. Then turn

off the main switch and unplug the power cable from

the wall outlet, for safety purposes.

• After the lamp is turned off, the lamp cannot be

switched on again for 60 seconds as a precaution-

ary measure. It will take another 60 seconds before

the lamp indicator goes off. If you wish to turn on

the projector again, wait until the indicator is off

then press the POWER button.

• The exhaust fan rotates faster when the tempera-

ture around the projector rises.

• When the temperature around the projector becomes

too high, the sign “TEMP!!” blinks red on the screen.

If the temperature stays too high, the lamp will be

shut off automatically .

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Comments to this Manuals

No comments

Mitsubishi S490 User Manual Page 14

Comments to this Manuals

Related products and manuals for Data projectors Mitsubishi S490