Mitsubishi Lancer Evolution VIII MR Technical Information download pdf (Page 114)

4G6 – TIMING BELT

3. Push the V.V.T. sprocket firmly to the end and, holding the

hexagonal part of the camshaft with a wrench, check that the V.V.T.

sprocket does not rotate.

4. Hold the hexagonal section of the camshaft with a wrench and

tighten the V.V.T. sprocket bolt to the specified torque of 65 ±5 N-m.

5. Hold the hexagonal section of the camshaft with a wrench and

check that the V.V.T. sprocket does not rotate.

Note :

This check shows that the V.V.T. sprocket is locked at the maximum

delay angle by the interior pin.

Installation of plug cap

Note :

The washer must not be reused.

1. Install the washer on the plug cap.

2. Hold the hexagonal section of the camshaft with a wrench and

tighten the plug cap to the specified torque of 32±2 N-m.

B*

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 128 129

No comments

Mitsubishi Lancer Evolution VIII MR Technical Information Page 114