Mitsubishi MDT652S Specifications Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 57
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
English-15
English
P-2 Installing the monitor
Carry out as necessary
Using the wall mount or ceiling mount
Lay the screen face down
Lay the protective sheet on a table, which was wrapped around
the monitor when it was packaged, beneath the screen surface
so as not to scratch the screen surface.
Failure to follow the correct mounting procedures can result
in damage to the equipment or injury to the user or installer.
Product warranty does not cover damage caused by improper
installation.
Failure to follow these recommendations can void your
warranty.
Use M8 screws (having a length 15 mm longer than the
thickness of the mounting bracket) and tighten them securely.
Prevent the screws from loosening using spring washers, etc.
MITSUBISHI ELECTRIC recommends using mounting interface
that comply with TÜV-GS and/or UL1678 standard in North
America.
CAUTION:
For preventing the monitor from falling.
Install the monitor with metal brackets for wall or
ceiling installation (commercially available) on your own
responsibility. For detailed procedures of installation, refer
to the instructions of the metal brackets.
To lessen the probability of injury and damage resulting
from fall of the monitor in case of earthquake or other
disaster, be sure to consult the bracket manufacturer for
installation location.
To lessen the risk of falling of the monitor, thread
commercially available rope through the handles at the
right and left of the monitor and secure the rope to the wall
mount brackets or ceiling mount brackets.
Do not sleep where the monitor may topple over or fall in
case of an earthquake or other disaster.
749 749
200 200
Handles
Protective Sheet
(mm)
Table
200 200
436.5436.5
Installing in the portrait position
Conditions:
MDT651S can be installed in the portrait position, under the
following conditions:
CAUTION:
Portrait position is available only when the monitor is wall-
mounted or ceiling-mounted.
The stands (legs) can not be fi tted to the monitor in the portrait
position.
Placing the monitor in the portrait position will shorten the
average life of the LCD backlight.
Operation Environment (Temperature) shall be limited, as
shown below:
Operation Environment:
Temperature 5 - 35°C / 41 - 95°F
Humidity 20 - 80% (without condensation)
Place the monitor in the position shown below.
Do not place the monitor in landscape in any other manner than
shown.
Optional speakers (SP-422V) can not be attached when the
LCD mon
itor is installed in the portrait position.
How to set-up
The “
” logo should be on the LEFT side when
viewed from the front of the monitor.
90° Clockwise
Portrait
Portrait
logo
Landscape
(SP-521S)
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 56 57

Comments to this Manuals

No comments