Mitsubishi HD-5000A Specifications Page 99

  • Download
  • Add to my manuals
  • Print
  • Page
    / 116
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 98
1-800-366-5412 • www.encoder.com • sales@encoder.com
99

The RX/TX Repeater retransmits signals from an encoder output in order to drive
signals over a longer distance with reduced noise and distortion free waveforms.
The input is equipped with a Differential Line Receiver and a Differential Line Driver.
It takes the differential signals (A, A, B, B’, Z, Z’) , squares the signals up, and then
repeats the signals at the outputs.
Benefits are greater immunity from electrical noise, signal distortion, and
interference, especially with long cable runs. The output signal can be 5 VDC or an
amplitude equivalent to Vcc.

Repeat differential signals for data transmission over long distances. To properly
terminate differential signals to eliminate/reduce signal distortions. Increase output
current drive capability in order to drive multiple receivers

Supply Source (Vcc)......... 5 to 24 VDC
Current Consumption ..... 20 mA max (plus encoder and output load requirements)
Max Frequency ............... Up to 1 MHz
Enclosure ......................... IP54 (dust proof)
Earth Circuit ................... Grounded to Case
Input Voltage ................... 24 VDC Max Diff
Output Voltage ................ 5 VDC or Vcc
Output Current ............... 30 mA/Channel Max
Stock #
INPUT OUTPUT
Differential Line
Receiver - MAX 3095
Differential Line
Driver 7272
100020-13 5V Vcc
100020-14 5V Vcc
2
100020-15 6-12V Vcc
100020-16 6-12V Vcc
2
100020-17 13-24V Vcc
100020-18 13-24V Vcc
2
1
Vcc should range between 5-24 VDC.
2
Outputs will be equivalent to voltage applied to Vcc (Pin P1-15)
THIRD ANGLE PROJECTION
12/27/05
RXTX ENCLOSURE
RXTX-ENC
B NONE 1 1
-
INITIAL RELEASE
-
RXTX-ENC
DESCRIPTIONLTR
REVISIONS
DATE
PART NUMBER
NEXT ASSEMBLY
ISSUE DATE
PREV ASSEMBLY
ENCODER PRODUCTS COMPANY
P
TOLERANCE
DATE
+
.1˚
PRJ ENG
.005
DECIMAL
ANGULAR
+
-
.01
DECIMAL
-
+
QC
MFG
CK
INITIAL
DR
E
C
DWG SIZE
NAME AND TITLE
DWG NUMBER
REV.
SCALE
-
OFSHEET
GMA 12/23/05
2.520 [64.00]
5.000 [127.00]
4.488 [114.00]
5.472 [139.00]
1.181 [30.00]
1.732 [44.00]
1.181 [30.00]
Ø0.197 [Ø5.00]
All dimensions are in inches with a tolerance of +0.005” or +0.01” unless otherwise specified.
Metric dimensions are given in brackets [mm].


(Specify stock # when ordering)
Differential = A,A’, B,B’, Z,Z’
Single Ended = A, B, Z
rx/Tx repeaTer
Page view 98
1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 115 116

Comments to this Manuals

No comments