Mitsubishi Montero 1987 Service Manual download pdf (Page 9)

INTRODUCTION

- Precautions Before Service

nm (in.)

so0059

PARTS

When replacing parts, use MITSUBISHI genuine parts.

VEHICLE WVASHING

If high-pressure car-washing equipment or steam car-washing

equipment is used to wash the vehicle, be sure to maintain the

spray nozzle at a distance of at least 300 mm (1 1.8 in.) from

any plastic parts and all opening parts (doors, luggage

compartment, etc.).

SERVICING THE ELECTRICAL SYSTEM

When servicing the electrical system, disconnect the negative

cable terminal from the battery.

Caution

Before connecting or disconnecting the negative cable, be

sure to turn off the ignition switch and the lighting switch.

(If this is not done, there is the possibility of semiconductor

parts being damaged.)

WIRING HARNESSES

1. Secure the wiring harnesses by using clamps so that there

is no slack. However, for any harness which passes to the

engine or other vibrating parts of the vehicle, allow some

slack within a range that does not allow the engine

vibrations to cause the harness to come into contact with

any of the surrounding parts. Then secure the harness by

using a clamp.

In addition, if a mounting indication mark (yellow tape) is

on a harness, secure the indication mark in the specified

location.

2. If any section of a wiring harness contacts the edge of a

part, or a corner, wrap the section of the harness with tape

or something similar in order to protect it from damage.

F161711

* :, :,

1 STB Revision

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 283 284

No comments

Mitsubishi Montero 1987 Service Manual Page 9