Mitsubishi 4G6 Series 1991 Specifications download pdf (Page 85)

4G6 ENGINE (E-W) -

Front Case, Counterbalance Shafts and Oil Pan

11A-10-3

REMOVAL SERVICE POINTS

OIL PAN REMOVAL

(1) Remove all oil pan bolts.

(2) Drive in the special tool between the cylinder block and

oil pan.

NOTE

Never use a screwdriver or chisel, instead of the service

tool, as a deformed oil pan flange will result in oil leakage.

OIL PAN LOWER REMOVAL

(1) Apply a wood block to the oil pan side and remove the

oil pan lower by tapping lightly on it with a plastic hammer.

Caution

Do not use a scraper or special tool to remove

the oil pan.

OIL PAN UPPER REMOVAL

(1) Remove all bolts.

(2) Screw a bolt into bolt hole A shown to remove the oil

pan.

Caution

Do not use a scraper or special tool to remove

the oil pan.

PLUG REMOVAL

(1) If the plug is too tight, hit the plug head with a hammer

two to three times, and the plug will be easily loosened.

FLANGE BOLT REMOVAL

(1) Remove the plug on the side of cylinder block.

(2) Insert a Phillips screwdriver (shank diameter 8 mm) into

the plug hole to lock the counterbalance shaft.

RevisedPWEE9616-A

Aug. 1998Mitsubishi Motors Corporation

6EN0698

MD998727

MD998162

MD998783

6EN1026

Plug

Screwdriver

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 107 108

No comments

Mitsubishi 4G6 Series 1991 Specifications Page 85