Mitsubishi MS-18RV Service Manual download pdf (Page 68)

OPERATING PROCEDURE PHOTOS

Photo 5

Photo 6

Photo 7

Compressor

Stop valve

Heat exchanger

Accumulator

Screws

Rear

panel

Side

panel

Rear guard

4. Removing the heat exchanger and compressor

(1) Remove the screws of the rear panel. Remove the screws

of the valve bed and the valve bed. (The valve bed is

fixed by the catches on the right and left sides. Lift it to

remove.)

Open the rear panel to the rear to remove.

NOTE :

All panels are fixed by catches, and must be removed by

up and down.

(2) Remove the screws of the side panel and the side panel.

(3) Remove the screws of the rear guard and the rear guard.

(4) Remove the screws of the separator support plate and

the separator support plate.

(5) Remove the screws of the motor support and the motor

support.

(6) Remove the relay panel.

Disconnect the fan motor lead wires.

(7) Remove the soundproof felt.

(8) Remove the screws of the separator and the separator.

(9) Recover gas from the refrigerant circuit.

(10)

Remove the screws of the heat exchanger and the heat

exchanger.

Detach the welded part of pipe.

(11)

Remove the nuts of the compressor and the compressor.

Detach the welded part of the suction pipe and the dis-

charge pipe.

Sound

proof felt

OB271--3.qxp 2/7/01 9:08 AM Page 68

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 74 75 76

Comments to this Manuals

No comments

Mitsubishi MS-18RV Service Manual Page 68

Comments to this Manuals

Related products and manuals for Split-system air conditioners Mitsubishi MS-18RV