Mitsubishi PLA-RP Installation Manual download pdf (Page 11)

6. Electrical work

Mode

Power failure automatic recovery

Indoor temperature detecting

LOSSNAY connectivity

Power voltage

Settings

Not available

Available *1

Indoor unit operating average

Set by indoor unit’s remote controller

Remote controller’s internal sensor

Not Supported

Supported (indoor unit is not equipped with outdoor-air intake)

Supported (indoor unit is equipped with outdoor-air intake)

240 V

220 V, 230 V

Mode no. Setting no.

Initial setting

setting

02 2

03 2

Mode

Filter sign

Fan speed

No. of air outlets

Installed options (high-performance ﬁ lter)

Up/down vane setting

Settings

100Hr

2500Hr

No ﬁ lter sign indicator

Silent

Standard

High ceiling

4 directions

3 directions

2 directions

Not supported

Supported

Equipped with vanes (vanes angle setup

)

Equipped with vanes (vanes angle setup

)

Equipped with vanes (vanes angle setup

)

Mode no. Setting no.

Initial setting

setting

07 2

08 2

09 2

11 2

*1 When the power supply returns, the air conditioner will start 3 minutes later.

*2 Power failure automatic recovery initial setting depends on the connecting outdoor unit.

6.3.3 How to set the ﬁ xed up/down air direction (Only for wired remote

controller and PUHZ-RP/P, PU(H)-P application)

Explanation of word

• "Refrigerant address No." and "Unit No." are the numbers given to

each air conditioner.

• "Outlet No." is the number given to each outlet of air conditioner.

(Refer to the right.)

• "Up/Down air direction" is the direction (angle) to ﬁ x.

• Only the particular outlet can be fixed to certain direction with the

procedures below. Once ﬁ xed, only the set outlet is ﬁ xed every time air

conditioner is turned on. (Other outlets follow UP/DOWN air direction

setting of the remote controller.)

Horizontal airflow

Downward

Fixed setting

The airflow direction of

this outlet is fixed

in particular direction.

Remote controller setting

The airflow direction of

this outlet is controlled by

the airflow direction setting of

remote contoller.

When it is cold because of direct airflow,

the airflow direction can be fixed

horizontally to avoid direct airflow.



MITSUBISHI

ELECTRIC

label

Outlet No.4

Outlet No.2

Outlet No.3

Outlet No.1

Note: "0" indicates all outlets.

Reset 1

horizontal

2345

Function table

Select unit number 00

Select unit numbers 01 to 03 or all units (AL [wired remote controller]/07 [wireless remote controller])

RG79D251K01_EN_0227.indd 11RG79D251K01_EN_0227.indd 11 28/02/2007 09:48:5628/02/2007 09:48:56

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Comments to this Manuals

No comments

Mitsubishi PLA-RP Installation Manual Page 11

Comments to this Manuals

Related products and manuals for Split-system air conditioners Mitsubishi PLA-RP