Mitsubishi 20-MYA Specifications Page 103
- Page / 116
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
- 101 -
HOW TO OPERATE
If you use the LCD remote controller, you can operate below method.
Please consult operate method with dealer, if you use field supply control parts.
For purposes of explanation, all the displays on this page are shown
in their lit condition. This configuration does not occur in the actual
unit.
Operation mode
Displays the status of operation.
[Checking] Display
This displays indication when some abnormality occurs in the unit.
[Current/start/ending time] Display
[Set temperature] Display
Displays the set temperature.
[Operation] Lamp
Lights up during operation, goes off during stop.
[Fan speed] Display
This displays indication High-speed or Low-speed.
[Key lock] Display
This display indication during key lock function active.
[Room temperature] Display
Displays the temperature of the air sucked in during operation.
Display section
* Make sure that the power supply is turned ON before use.
(Keep the power supply turned ON at all times when the air conditioner
is in use. Use of the unit without power can result in compressor failure.)
Check and confirm the power circuit before use. For the contents, refer to
the previously described chapter [Crucial points to be observed for safety].
Before starting operation
1. ON / OFF
Start an operation
Press the [ON/OFF] button
Operation lamp lights up and operation starts.
Stop an operation
Press the [ON/OFF] button again
Operation lamp goes off and operation stops.
* Once the buttons have been set, pressing of the [ON/OFF] button
only can repeat the same operation thereafter.
* During operation, the operation lamp above the [ON/OFF] button
lights up.
Operation lamp
A
B
C
D
E
F
G
H
[Timer Hold / Resume setting] Display
J
E
1
1
B
C
A
H
G
D
E
F
1
E
Even if the operation button is pressed immediately after the
operation is once stopped, operation is not restarted for about
3 minutes.
This function protects the machine. It automatically starts
operation after the lapse of approximately 3 minutes.
J
Warning:
Caution:
- DATA BOOK 1
- SPECIFICATION GUIDELINES -113 3
- SAFETY FOR USE 4
- A COMPLETE LINE UP 6
- FEATURES 7
- DESCRIPTIONS 7
- TYPICAL INSTALLATION EXAMPLE 8
- MECHANICAL SPECIFICATIONS 8
- MODEL-DESIGNATION BREAKDOWN 9
- PE-10 MYC 9
- SPECIFICATIONS 10
- PEH-5,7,8MYA 11
- Heat pump 11
- PEH-10,15,20MYA 12
- ELECTRICAL DATA 13
- PEH-5,7,8MYA-EU 14
- PEH-10,15,20MYA-EU 16
- SELECTION PROCEDURE 18
- Factor for Various Air Flow 19
- CAPACITY TABLES 20
- Heating Capacity 21
- (Standard Air Flow) 21
- (PEH only) 39
- FAN PERFORMANCE 40
- PE-15MYC1-EU 41
- PEH-15MYA-EU 41
- PE-20MYC-EU 41
- PEH-20MYA-EU 41
- (1) Shape of belt groove 42
- SOUND DATA 43
- OUTLINE DIMENSIONS 45
- PE(H)-10 46
- PE(H)-15 46
- PE(H)-20 47
- PU(H)-7,8,10 48
- (Upper blow) 48
- PUH-8,10 49
- (Side blow) 49
- PUH-15,20 50
- PAC-204RC 52
- Attach the accessory 53
- LOW AMBIENT 64
- COOLING PARTS 64
- MF1 Note 65
- PE-15MYC1-EU PE-20MYC-EU 66
- PEH-15,20MYA-EU 67
- REFRIGERANT SCHEMATICS 68
- SAFETY & CONTROL DEVICES 69
- PEH-7,8,10MYA-EU 70
- SPECIAL ORDER 71
- PHYSICAL DATA 72
- [INDOOR AIR CIRCUIT] 73
- [EVAPORATOR] 73
- [OUTDOOR AIR CIRCUIT] 73
- [CONDENSER] 73
- [ENCLOSURE AND FRAME] 74
- 2-EU PUH-10MYE1-EU 78
- INSTALLATION 81
- PU(H)-7,8, 10 (Upper blow) 82
- (1) At a single installation 83
- Indoor unit 84
- 3. Installation of the unit 85
- Outdoor unit 85
- Duct construction 86
- Lifting method 86
- Piping connection 87
- Refrigerant piping 88
- Airtight test 89
- Evacuation 89
- Additional refrigerant charge 89
- Drain piping 90
- Electric wiring 91
- Upper blow 92
- PE(H)-7:Single phase 93
- Refer to (3)-4 94
- Refer to (3)-3 94
- Refer to (3)-5 94
- (Not change) 95
- Detail section A 96
- LCD remote controller inside 96
- Check items 97
- Obstacle blocking air inlet 98
- 2. Caution for use 99
- 3. Maintenance 99
- Flexion load (W) 100
- 1.4 kg 2.2kg 100
- V pulley 100
- 9. Troubleshooting 102
- HOW TO OPERATE 103
- 2. Selecting operation 104
- 4. Time setting 105
- 5. Other function 105
- 1. Outline 106
- 3. Parts 106
- 2. Caution 106
- 4. Installation 107
- 4-2. PUH-15,20 108
- 4-3-1. Install 109
- 4-3-2. Wiring 109
- Confirmation 110
- Fan controller layout 110
- 6. Troubleshooting 111
- Thyristor module 114
- SPECIFICATION GUIDELINES 115
- DATA BOOK PE,PEH 116
Related products and manuals for Split-system air conditioners Mitsubishi 20-MYA
(26 pages)
(20 pages)
(13 pages)
(20 pages)© 2020, manymanuals.com. All rights reserved. | 0.890 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals