Mitsubishi 20-MYA Specifications Page 94
- Page / 116
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
- 92 -
(3) LCD remote controller.
(3)-2. Outline and inside drawing
(3)-1. Confirmation of parts
The following parts are contained in the carton box together with this manual.
Please check to make sure that everything is included.
1
2
3
4
Remote controller (upper case, lower case)
Pan-head screw with cross hole M4
Wooden screw 4.1 ✕ 16 (for installing unit directly on a wall)
Instruction manual
······································· 1
··················································· 2
············· 2
················································································ 1
Q'TY
(3)-3. Installation
(1) Decide where you want to install the LCD remote controller (switch box)
In deciding, please observe the following precautions:
Do not install the LCD remote controller in locations, which are:
Exposed to direct sunlight.
Susceptible to humidity and moisture.
Near a source of heat.
Near machines emitting high-frequency waves. (High-frequency welders, etc.)
Switch box for two units
Connecting wire (Length : below 20m size : 0.75mm
2
)
Lock nut, bushing
(2) Install the lower case on the switch box.
Caution :
Over-tightening the screws can cause deformation and / or cracks on the lower case.
Install the LCD remote controller on a wall with flat surface.
Installation on an uneven surface can cause cracks on the LCD and other failure.
Switch box for
two units
Connecting wire
Pan-head screws
with cross holes
When installing
on switch box
Snap the upper case into place.
Hook the two upper claws into their slots, and shut
the lower part as shown in the right diagram.
Caution :
Press the case until it snaps shut.
To use, remove the protective sheet on the operation section.
Connect to terminal
1) Procure the following parts locally :
Seal the wire lead-in hole completely with putty
Caution :
Do not turn the screwdriver while it is inserted into the slot.
Doing so can result in damage to the slot.
TB1
DIP SW
TB2
1
ON
234
Controller boardOutline (Key cover open)
COMP2
COMP1
4W V
ERROR
24VAC(N)
24VAC(L)
FAN HI
FAN LO
EXT
SENSOR
JH
INT / EXT
Refer to (3)-4
Refer to (3)-3
Refer to (3)-5
To remove the upper case, insert a screwdriver(-)
into one of the slots and slide it in the direction
of the arrow shown in the diagram on the right.
- DATA BOOK 1
- SPECIFICATION GUIDELINES -113 3
- SAFETY FOR USE 4
- A COMPLETE LINE UP 6
- FEATURES 7
- DESCRIPTIONS 7
- TYPICAL INSTALLATION EXAMPLE 8
- MECHANICAL SPECIFICATIONS 8
- MODEL-DESIGNATION BREAKDOWN 9
- PE-10 MYC 9
- SPECIFICATIONS 10
- PEH-5,7,8MYA 11
- Heat pump 11
- PEH-10,15,20MYA 12
- ELECTRICAL DATA 13
- PEH-5,7,8MYA-EU 14
- PEH-10,15,20MYA-EU 16
- SELECTION PROCEDURE 18
- Factor for Various Air Flow 19
- CAPACITY TABLES 20
- Heating Capacity 21
- (Standard Air Flow) 21
- (PEH only) 39
- FAN PERFORMANCE 40
- PE-15MYC1-EU 41
- PEH-15MYA-EU 41
- PE-20MYC-EU 41
- PEH-20MYA-EU 41
- (1) Shape of belt groove 42
- SOUND DATA 43
- OUTLINE DIMENSIONS 45
- PE(H)-10 46
- PE(H)-15 46
- PE(H)-20 47
- PU(H)-7,8,10 48
- (Upper blow) 48
- PUH-8,10 49
- (Side blow) 49
- PUH-15,20 50
- PAC-204RC 52
- Attach the accessory 53
- LOW AMBIENT 64
- COOLING PARTS 64
- MF1 Note 65
- PE-15MYC1-EU PE-20MYC-EU 66
- PEH-15,20MYA-EU 67
- REFRIGERANT SCHEMATICS 68
- SAFETY & CONTROL DEVICES 69
- PEH-7,8,10MYA-EU 70
- SPECIAL ORDER 71
- PHYSICAL DATA 72
- [INDOOR AIR CIRCUIT] 73
- [EVAPORATOR] 73
- [OUTDOOR AIR CIRCUIT] 73
- [CONDENSER] 73
- [ENCLOSURE AND FRAME] 74
- 2-EU PUH-10MYE1-EU 78
- INSTALLATION 81
- PU(H)-7,8, 10 (Upper blow) 82
- (1) At a single installation 83
- Indoor unit 84
- 3. Installation of the unit 85
- Outdoor unit 85
- Duct construction 86
- Lifting method 86
- Piping connection 87
- Refrigerant piping 88
- Airtight test 89
- Evacuation 89
- Additional refrigerant charge 89
- Drain piping 90
- Electric wiring 91
- Upper blow 92
- PE(H)-7:Single phase 93
- Refer to (3)-4 94
- Refer to (3)-3 94
- Refer to (3)-5 94
- (Not change) 95
- Detail section A 96
- LCD remote controller inside 96
- Check items 97
- Obstacle blocking air inlet 98
- 2. Caution for use 99
- 3. Maintenance 99
- Flexion load (W) 100
- 1.4 kg 2.2kg 100
- V pulley 100
- 9. Troubleshooting 102
- HOW TO OPERATE 103
- 2. Selecting operation 104
- 4. Time setting 105
- 5. Other function 105
- 1. Outline 106
- 3. Parts 106
- 2. Caution 106
- 4. Installation 107
- 4-2. PUH-15,20 108
- 4-3-1. Install 109
- 4-3-2. Wiring 109
- Confirmation 110
- Fan controller layout 110
- 6. Troubleshooting 111
- Thyristor module 114
- SPECIFICATION GUIDELINES 115
- DATA BOOK PE,PEH 116
Related products and manuals for Split-system air conditioners Mitsubishi 20-MYA
(26 pages)
(20 pages)
(13 pages)
(20 pages)© 2020, manymanuals.com. All rights reserved. | 3.443 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals