Mitsubishi CS-40507 Instruction Manual download pdf (Page 10)

2. INSTALLATION

Remove the drive cover following the inverter instruction manual and

install the option unit using the following procedure:

2.1 Pre-Installation Checks

(1) Check the inverter type.

You may use the option unit only with a FR-A500(L)/F500(L) series

inverter. You must not use it with any other series (e.g. A200E, A200,

A100, Z and F series). These other series inverters have a different

option connector to prevent installation; if you force the connector, you

may damage the inverter as well as the option unit.

(2) Make sure the inverter line power is off.

You may damage the option unit if you install it with the line power

connected.

Mounting Procedure

(3) Insert this option unit into the inverter's OPTION PORT# 3 only.

(4) Carefully insert the connector of the option unit into the connector of

the inverter. Use the two mounting holes and the guide hole to align

the bottom board with the matching machine screw inserts and the

plastic guide pin on the inverter. Make sure that the inverter option is

firmly seated in the inverter and the connector is fully plugged in.

Also be sure to fit the unit into the option fixing hook (It is available in

Aug., 2000).

HAZARDOUS VOLTAGE PRESENT

Always isolate power from the inverter and wait 10 minutes

until the bus charge light is off to ensure the charge lamp has

gone out before inserting or removing this option unit or

touching the terminals.

REMARKS

When you insert the option unit to the inverter, please push down the plastic

nuts on the top-board. (Please refer to Figure 1)

CAUTION

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 37 38

No comments

Mitsubishi CS-40507 Instruction Manual Page 10