Mitsubishi MDT652S Specifications download pdf (Page 35)

English-35

English

To RS-232C

connector IN

To CAT5 RGB5

connector OUT

To CAT5 RGB5

connector OUT

RS-232C cable

USB cable

RS-232C cable

CAT5 cable CAT5 cable

Type A Type B

Monitor

To RS-232C

connector IN

To RS-232C

connector IN

To CAT5

connector OUT

CAT5 Tx BOX

(accessory)

To RS-232C

connector OUT

To CAT5 RGB5

connector IN

To CAT5 RGB5

connector IN

To RS-232C

connector OUT

* This connection isn’t necessary

when the USB COM port is used.

U-11 Remote control

Carry out as necessary

RS-232C/RS-485 Remote control

By connecting multiple LCD monitors and a computer using RS-232C cables (commercially available) or CAT5 cables (commercially

available), you can control the monitors from the computer via the supplied CAT5 Tx BOX for the following operations:

• Power ON or OFF

• Switching between input signals

• Volume control and mute

• Auto setup

Connection

Connection by RS-232C (For RS-232C cable (commercially available), the reverse type cable should be used.)

Connection by CAT5 RS-485 (For CAT5 cable (commercially available), the straight type cable should be used)

• Before making connections, turn off the personal computer and the monitors.

• Start the personal computer ﬁ rst, and then turn on the monitors. (Otherwise, the com port may be unusable.)

NOTE:

For connection with a 25-pin serial port connector on the computer, a conversion adapter (commercially available) is required.

1) Interface

PROTOCOL RS-232C/RS-485 (CAT5)

BAUD RATE 9600 [bps]

DATA LENGTH 8 [bit]

PARITY BIT NONE

STOP BIT 1 [bit]

FLOW CONTROL NONE

This LCD monitor uses RXD, TXD and GND lines for RS-232C control.

CAT5 Tx BOX uses RXD, TXD, DTR, and GND lines for RS-485 control with RS-232C connector.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 56 57

Comments to this Manuals

No comments

Mitsubishi MDT652S Specifications Page 35

Comments to this Manuals

Related products and manuals for TVs & monitors Mitsubishi MDT652S