Onerator’s
Manual
name0
UUlilR
WXSTM
50 INCH
3.0 PRECAUTIONS
3.1
Installation
This game is designed for indoor use only.
It must
nor
be installed outdoors. The
following conditions must be avoided:
1.
Direct exposure to sunlight, high humidity, direct water contact, dust, high
heat or extreme cold.
2.
Vibration. The game must be installed on a level surface with levelers
properly adjusted.
Do nof install in an area such
that
the
game would present an obstacle in case of an
emergency (i.e., near fire equipmenf
or
emergency exists).
3.2
Handling
1.
Before operating the game, make sure that the main AC power hookup
includes a safety ground. This will ensure safe operation as well as
compliance with the applicable FCC and UL regulations. Measure the AC
power line voltage. Verify that the voltage source is between 110 and 125
VAC.
2.
Before replacing any parts, turn the AC power OFF and unplug the game.
3.
The game power supply includes areas where 120 VAC is present. Take
care at all times to avoid electrical shock whenever inspecting or adjusting
the game.
4.
Do not attempt to repair the Printed Circuit Board (PCB) on-site. It contains
sensitive integrated circuit chips that could be easily damaged, even by the
small internal voltage of a multimeter. Always return the PCB to your
distributor for any repairs. PCB assemblies must be returned as complete
Always return levelers to the extreme up position before moving the
game.
When moving the game always remove the pedal assembly and
.pack
it
of high voltage inside. If trouble is suspected in the
monitor, refer to the troubleshooting guide in the back of
Comments to this Manuals