Mitsubishi VS-5041 Operator's Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 50
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
name=
TUflE
CR!XSTM
50 INCH
Operator’s Manual
4.0 INSTALLATION
Note: Shipping damage may void the warranty. In case of shipping damage, contact your
distributor and the transportation carrier immediately.
1.
Unpack the marquee and accessories box, and identify the following items:
1 ea
pedal assembly
4 ea
button head screws, M5 x 16. blk, w/flat and lock washers
4 ea
hex head bolts, 3/8-16 x
1-W”
with washers
4 ea
hex
head
bolts, 3/8-16 x 2”, with washers
3 ea
hex head bolts,
l/4-20
x 2”, with
flat and
lock washers
2
ea cabinet joint right angle brackets
1 ea extension harness, for dollar bill acceptor. (AP50-04271-00)
2.
3.
Locate the rear component door panel keys attached to the back of the
monitor cabinet. Open and remove the component door panel.
Verify that the monitor remote controller and manual are in the back of the
monitor cabinet. (These
wilt
not be needed for day-to-day operation of the
game).
4.
5.
Connect the 12-pin, g-pin, and 4-pin connectors between the 2 cabinets.
With the monitor cabinet and player cabinet approximately level, position
them such that the holes in the joint brackets will line up with the cabinet’s
holes.
6. Install the brackets using the 3/8-16 bolts with washers. The 2 inch long bolts
go into the player cabinet, the l-1/4 inch bolts into the monitor cabinet.
Tighten them to about 20
f&lb.
7.
8.
Connect the pedal extension harness.
Position the pedal assembly such that the bracket holes align with the
threaded holes in the pedal assembly, and install the 4 ea M5 x 16 screws
with washers.
Place the marquee on top of the monitor cabinet, making sure that the
electrical connector is hooked up. Install and tighten the 3 ea I/4-20 bolts
with washers.
With the game in its installation position, lower the leg levelers,
Plug in the main AC power cord, and turn the game ON. The power switch is
located in the lower rear of the monitor cabinet.
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 49 50

Comments to this Manuals

No comments