Mitsubishi DX-TL930E Instruction Manual download pdf (Page 20)

••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••

Initial settings

4. Turn the JOG dial to move the cursor to INITIALIZE, and

turn the SHUTTLE ring twice to the right .

ID5:RDD

LIMIT 4GB @INITIALIZE

BOOT UP DELAY 00

Turn the SHUTTLE RING

> > to EXECUTE.

The unit will initialize its system when data is erased

from either its built-in hard disk or hard disks connected

to ID0 through ID3. Data is not erased from hard disks

connected to ID4 and ID5. Press the Power button when

you wish to exit this screen without initializing data.

Settings, however, will not be altered.

When you wish to reset storage capacity limits, first

turn off the main power, then, keeping the REC button

pressed, turn on the main power again. The <DEVICE

CHECK> menu will appear, and settings can then be

altered.

5. The unit will start setting up.

■ Confirming the connected device

1. Press the INFO button.

• The <INFORMATION> menu will appear.

2. Turn the JOG dial to select CONNECTED SCSI DEVICE.

<INFORMATION>

RECORDED PERIOD

@CONNECTED SCSI DEVICE

3. Turn the SHUTTLE ring to the right.

• The <CONNECTED SCSI DEVICE> menu will appear.

<CONNECTED SCSI DEVICE>

SCSI ID0:HDD(30GB)

ID1:HDD( 9GB)

ID2:NONE

ID3:NONE

ID4:NONE

ID5:NONE



LIMIT 4GB

Parameters for ID4 and ID5 will display “NONE”

when no archive or copying devices are connected to

the unit.

■ Setting this unit to delay the boot up time

Because the unit searches for connected devices when power

is turned on, peripheral devices must be turned on before power

is turned on to the digital recorder. To handle peripherals which

take a long time to start up, the unit can be preset to delay the

timing of its search for these devices.

1. Press the POWER button while pressing the REC button to

turn the power on.

• The <DEVICE CHECK> menu will appear.

<DEVICE CHECK>

SCSI ID0:HDD(30GB)

ID1:HDD( 9GB)

ID2:NONE

ID3:NONE

ID4:NONE

ID5:NONE

@LIMIT OFF INITIALIZE

BOOT UP DELAY 00

2. Turn the JOG dial to select BOOT UP DELAY, and turn the

SHUTTLE ring to the right.

• The sub-item of the BOOT UP DELAY will start flashing.

ID5:RDD

LIMIT OFF INITIALIZE

@BOOT UP DELAY 00

3. Turn the JOG dial to set the delay time, and turn the

SHUTTLE ring to the right to enter the selection.

• You can set up to 99 seconds.

ID5:RDD

LIMIT OFF INITIALIZE

@BOOT UP DELAY 10

When BOOT UP DELAY is set and timer recording

is performed, the unit will begin recording later than

the time set as the recording time.

4. Press the POWER button.

• The power of this unit will be turned off.

5. Press the POWER button again.

• This unit will start setting up after the preset delayed time

has passed.

If a different peripheral recording device was con-

nected from the last time the unit was booted up, the

<DEVICE CHECK> menu will appear.

Initial settings (continued)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 76 77

Comments to this Manuals

No comments

Mitsubishi DX-TL930E Instruction Manual Page 20

Comments to this Manuals

Related products and manuals for Recording Equipment Mitsubishi DX-TL930E