Mitsubishi PU-5TJSA Service Manual download pdf (Page 5)

● Remote controller

Settings remain in effect until changed. Air

conditioner can be operated by simply pushing

ON/OFF button once settings have been

made.

MITSUBISHI ELECTRIC

TIMER TEMP

TIMER/TEMP.

DOWN

POWER

COOL

ON/OFF

LOUVER

MODE

SELECT

FAN

SPEED

TIMER

MODE

DRY

FAN

HIGH

LOW

AUTO

STOP

START

Display Panel Operating panel

TIMER / TEMP.

This button is used to change

between display of room tem-

peratue and display of remain-

ing timer time durining “AUTO

STOP” operation. Green lamps

light in selected display mode.

Lamps display remaining

timer time or room temper-

ature.

Remaining timer time display

Lamps indicate time remaining

until timer stops timed operation.

Green lamps corresponding to

remaining number of hours light.

Room Temperature display

Lamps display temperatue set-

ings and actual room tempe-

ratues.

Temperatue settings.

Green lamps light.

Temperatue in room.

Green lamps flash.

(Example display readings are

for explanations only; actual dis-

play readings will differ.)

ON / OFF button

Pushing button starts

operation. Pushing again

stops operation. Green

lamp remains lit during

operation.

MODE SELECT button

This button is used to

change between cooling.

ventilation and DRY(or heat-

ing)operation modes.One of

three green lamps light to

indicate mode in effect.

FAN SPEED button

This button is used to

change between low and

high fan speeds. One of

two green lamps lights to

indicade fan speed in

effect.

Swing Louver Button

Used to automatically

disperse airflow vertically.

Air is blown in one

direction when louver is

not turning. Lamp lights

effect.

TIMER MODE button

Used for selecting timed

starting or stopping.Green

lamp light to indicate

timer mode selected.

UP and DOWN buttons

Temperature control (While ”TEMP” green lamp is

lit.)

Use UP and DOWN buttons to set desired temper-

ature between 18 and 29

Timed operation (While green “TIMER” lamp is lit.)

Use UP and DOWN buttons to set timed operation

between one and twelve hours.

Attention:

Pushing UP and DOWN buttons together for more than two seconds will initate “trial run” or “inspection” mode. Avoid

pushing these buttons simultaneously during normal operation. Push ON / OFF button to cancel trial run or inspection

mode if initiated by accident.

All green lamps turn off when air conditioner is stopped.

Avoid operation of buttons with fingernails or other sharp object. Sharp object may scratch operating panel.

*Heating operation mode is only available for models with built-in electric heater.

1 2 3 4 5 6 7 8 9 10 ... 51 52

Comments to this Manuals

No comments

Mitsubishi PU-5TJSA Service Manual Page 5

Comments to this Manuals

Related products and manuals for Split-system air conditioners Mitsubishi PU-5TJSA