Mitsubishi SR-SD1 Specifications download pdf (Page 124)

APPENDIX 3 EMC INSTALLATION GUIDELINES

1. Introduction

118

APPENDIX 3 EMC INSTALLATION GUIDELINES

1. Introduction

EMC Instructions became mandatory as of January 1, 1996. The subject products must have a CE mark

attached indicating that the product complies with the Instructions.

As the NC unit is a component designed to control machine tools, it is believed that it is not a direct EMC

Instruction subject. However, we would like to introduce the following measure plans to back up EMC

Instruction compliance of the machine tool as the NC unit is a major component of the machine tools.

(1) Methods of installation in control/operation panel

(2) Methods of wiring cables to outside of panel

(3) Introduction of members for measures

Mitsubishi is carrying out tests to confirm the compliance to the EMC Instructions under the environment

described in this manual. However, the level of the noise will differ according to the equipment type and

layout, control panel structure and wiring lead-in, etc. Thus, we ask that the final noise level be

confirmed by the machine manufacturer.

This section corresponds to the following Series.

MELDAS 600 Series

Matters related to the EMC measures in this manual have a priority over the details given in the

Connection Manual.

This section is an excerpt of the "EMC Installation Guidelines BNP-B2230". Only the

pages related to the M600 Series are given.

Refer to the "EMC Installation Guidelines [BNP-B8582-45]" for details on the drive

section (servo amplifier/spindle amplifier).

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 140 141

No comments

Mitsubishi SR-SD1 Specifications Page 124