Mitsubishi FR-S500 Instruction Manual download pdf (Page 27)

Run and operation

4.2 Run and operation

4.2.1 Parts of the operation panel

The operation panel cannot be removed from the inverter.

REMARKS

•When the parameter unit (FR-PU04) is used, operation from the operation panel is not

accepted. ( is valid)

RUN

EXT

MODE SET

RUN

EXT

STOP

RESET

Used to change the setting mode.

RUN

RUN indication

PU indication **

Lit to indicate PU

operation mode.

3-digit monitor LED

Shows the frequency,

parameter number, etc.

EXT indication **

Lit to indicate external

operation mode.

Setting dial

(Setting dial: Mistubishi inverter's dial)

Used to change the frequency

setting and parameter values.

This dial cannot be removed.

MODE Key

SET Key

Used to define each setting.

When the start command is given and the frequency command

is less than the strating frequency.

reset an alarm.

STOP/RESET Key

Used to give the forward

rotation run command.

Use Pr. 17 to set reverse

operation.

RUN Key

Used to switch between the

PU and external operation

mode. When using external

operation mode (operation

using the separately

connected frequency setting

potentiometer and start

signal), press this key to

light up the EXT indication.

(Change the Pr. 79 value to

use the combined mode.)

PU: PU operation mode

EXT: External operation mode

PU/EXT Key

Turns on/flickers* to indicate operation.

* RUN indication

On: Indicates that forward rotation operation is being performed.

Slow flickering (1.4s cycle): Indicates reverse rotation

Fast flickering (0.2s cycle): Indicates that operation is not being performed

but the was pressed or the start command was given.

** PU/EXT indication

Flickers slowly in the computer link operation mode.

STOP

RESET

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 98 99

Comments to this Manuals

No comments

Mitsubishi FR-S500 Instruction Manual Page 27

Comments to this Manuals

Related products and manuals for Power supply units Mitsubishi FR-S500