31
Operation by the start command of the terminal block
(external operation)
4
DRIVE THE MOTOR
4.4 Operation by the start command of the terminal
block (external operation)
4.4.1 Use the set frequency set by the operation panel (Pr. 79
= 3)
POINT
•Switch terminal STF(STR)-SD on to give a start command.
•Set "3" in Pr. 79 (External/PU combined operation mode 1).
•Refer to page 24 for the set frequency by the operation panel.
[
]
Three-Phase
AC power supply
SD
Inverter
R
S
T
U
V
W
Forward rotation start
Reverse rotation start
STF
STR
Operation panel
㧗㧙
Connection diagram
Moto
Set frequency
Turn to change it to the setting
value of " ".
Turn until (Pr. 79)
appears.
1.
Screen at powering on
The monitor display appears.
2.
Press to choose the
parameter setting mode.
Flicker
・・・
Parameter setting complete!!
SET
3.
4.
5.
6.
RUN
PU
EXT
Display
Operation
MODE
SET
MODE
Press to read the currently
set value.
SET
" " (factory setting) appears.
Press to set.
SET
The parameter
number read
previously appears.
Comments to this Manuals