Mitsubishi 4G6 series Specifications download pdf (Page 29)

4G6

ENGINE

<1992>

Timing Belt

SOHC

IIC-29

6EN0563

6EN056~

REMOVAL SERVICE POINTS

QAo

TIMING BELT REMOVAL

(1) Mark the belt running direction for reference in reinstalla-

tion.

NOTE

(1) Water or oil on the belt shortens its life drastically, so

the removed timing belt, sprocket, and tensioner must

be free from oil and water. These parts should not be

washed. Replace parts if seriously contaminated.

(2)

If there is oil or water on each part, check the front case

oil seals, camshaft oil seal and water pump for leaks.

QBQ

OIL PUMP SPROCKET REMOVAL

(1) Remove the plug on the left side of the cylinder block.

(2) Insert a Phillips screwdriver [shank diameter 8 mm

(31

in.)]

to block the left silent shaft.

(3) Remove the nut.

(4) Remove the oil pump sprocket.

CRANKSHAFT BOLT REMOVAL

(1) Using the special tool, hold the drive plate or flywheel.

(2) Remove the crankshaft bolt.

@I)

CRANKSHAFT SPROCKET REMOVAL

QEo

TIMING BELT “B” REMOVAL

(1) Make a mark on the back of the timing belt indicating the

direction of rotation so that it may be reassembled in the

same direction if it is to be reused.

NOTE

(1) Water or oil on the belt shortens its life drastically, so

the removed timing belt, sprocket, and tensioner must

be free from oil and water. These parts should not be

washed. Replace parts if seriously contaminated.

(2)

If there is oil or water on each part, check the front case

oil seals, camshaft oil seal and water pump for leaks.

TSB Revision

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 107 108

Comments to this Manuals

No comments

Mitsubishi 4G6 series Specifications Page 29

Comments to this Manuals

Related products and manuals for Engine Mitsubishi 4G6 series