Mitsubishi 4G6 series Specifications download pdf (Page 42)

C-42

466

ENGINE

<1992>

Timing Belt

DOHC

6EN015,

Wir>e

y-A

J040E

1)14

AUTO TENSIONER INSTALLATION

(1) If the auto tensioner rod is in its fully extended position,

reset it as follows.

(2) Clamp the auto-tensioner in the vise with soft jaws.

Caution

The plug protrudes at the bottom of the auto tensioner.

Insert a plain washer as illustrated to prevent the plug

from being in direct contact with the vise.

(3) Push in the rod little by little with the vise until the set hole

@ in the rod is aligned with the hole

in the cylinder.

(4) Insert a wire [I

(055

in.) in diameter] into the set

holes.

(5) Unclamp the auto tensioner from the vise.

(6) Install the auto tensioner to front case and tighten to the

specified torque.

Caution

Leave the wire installed in the auto tensioner.

I)J4

TENSIONER PULLEY INSTALLATION

(1)

Install the tensioner pulley in such direction that its two

small holes are arranged vertically.

TSB Revision

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 107 108

No comments

Mitsubishi 4G6 series Specifications Page 42