466
ENGINE
<1992>
-
Fuel and Emission Control Parts
IX-49
6EMO3RL
I
INJECTORS
6FU1920
SOHC
6EN0520
DOHC
6EN0521
INSPECTION
EGR VALVE
(1)
Check EGR valve for sticking or carbon deposits.
If such conditions exist, clean or replace EGR valve.
(2) Connect a hand vacuum pump to the nipple of EGR valve
and plug other nipple.
(3) Apply a vacuum of 500 mmHg (19.7 in. Hg) to make sure
that a vacuum is maintained. If there is a leak, replace the
EGR valve. In addition, check the valve for its opening and
closing by applying and removing a vacuum.
(1) Using an ohmmeter (circuit tester), test for continuity
between terminals of injector; the circuit should be closed.
If failure is detected, replace the injector.
Standard value:
Non-turbo 13
-
16
IR
[at
20°C
(68”F)l
Turbo
2
-
3
R
[at
20°C
(68”F)]
INSTALLATION SERVICE POINTS
I)A4
INJECTOR INSTALLATION
(1) Before installing an injector the rubber O-ring must be
lubricated with a drop of clean engine oil to aid in
installation.
(2) Install the injectors from the top end into the fuel rail.
Be careful not to damage the O-ring during
installat.ion.
I)B4
FUEL PRESSURE REGULATOR INSTALLATION
(1)
Before installing the pressure regulator the O-ring must be
lubricated with a drop of clean engine oil to aid in
installation.
1
TSB Revision
Comments to this Manuals