Mitsubishi P91W Instruction Manual Page 123

  • Download
  • Add to my manuals
  • Print
  • Page
    / 144
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 122
Installing Optional Accessories
113
The XcitaBlue conversion screen is held in place by adhesive-backed edge
guides. After the edge guides are installed, the conversion screen remains
centered and will not slide, even if you close the drawer rapidly.
To install the XcitaBlue conversion screen:
1. Perform a trial placement first, without removing the paper tape. Place
the edge guides in each corner of your transilluminator, as shown. The
edge guides should touch the inside of the drawer front and fit over the
edge of the metal transilluminator border (shown in red).
2. Remove the paper tape from the bottom surface of each edge guide.
3. Press each edge guide into position carefully, as it is difficult to
reposition them once the adhesive surfaces touch.
4. Calibrate your system to use this accessory by going to Edit >
Instrument Setup. Select the XcitaBlue Conversion Screen checkbox
under Illumination Options. The software prompts you to calibrate the
focus with height offset.
5. To visualize a sample using the XcitaBlue conversion screen, place the
screen between the edge guides.
Adhesive-backed
edge guide
Transilluminator
drawer front
Transilluminator
border edge
Page view 122
1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 143 144

Comments to this Manuals

No comments