Mitsubishi 4DQ5 Service Manual Page 47

  • Download
  • Add to my manuals
  • Print
  • Page
    / 120
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 46
(d) Install sleeve onto the rear end
of
crankshaft.
Apply clean engine oil
to
the internal surface
of
oil
seal
(I)
and secure it with bolts (2) by using oil seal
aligner,
(e) Apply Atomjet at the tip
of
bolts (3)
as
they fit into
four through-bolt holes in the bearing cap. Tighten
the bolts to a torque
of
0.4 kgm (2.9 lb.ft).
(8) Install the front plate
as
follows:
(a) Apply ThreeBond
1102 to the
both
sides
of
front
plate packing and attach the packing to the front
face
of
crankcase. Secure front plate (1) with
in-
jection pump installed with two bolts (2). The
tightening torque
of
the bolts
is
2.1
kgm (15.2Ib.ft).
(b) Heat camshaft gear to
150°C
to
180°C and fit
it to shaft.
(c) Slowly insert camshaft into crankcase.
-43-
1
,
jJ
--
Page view 46
1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 119 120

Comments to this Manuals

No comments