Mitsubishi 4DQ5 Service Manual download pdf (Page 83)

(3) Remove two brushes on the positive side, and take

off

the brush holder.

(4) Remove the yoke, and pull

off

the armature.

[NOTE]

Replace rubber packings fitted to the ends

yoke with new ones. Check and record the posi-

tion

locating notch for the yoke.

(5) Remove the cover, and take

off

the washer and

snap ring.

(6) Remove the center bracket by unscrewing two bolts.

Remove washers (several pieces) for adjusting the

pinion shaft axial play.

(7) Remove the snap ring holding the pinion, and

re-

move the pinion.

(8) Remove the lever springs (large and small), lever,

reduction gears, pinion shaft, etc.

-79-

[NOTE]

Lay the lever and springs in the order removed

that they can be restored to their original

positions.

(9) Replace the ball bearings. The ball bearings fitted

to the ends

armature can be removed with a

bearing puller. The front bracket bearing and

sleeve bearing (fitted to the inner race

ball

bearing) cannot be removed for replacement.

These bearings are

be replaced

an assembly

including the front bracket.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 119 120

No comments

Mitsubishi 4DQ5 Service Manual Page 83