Mitsubishi P91DW User Manual download pdf (Page 203)

Alpha Innotech User Manual, version 4

D.2

Cabinet Setup

When you remove the light cabinet from its shipping carton, it is already partially assembled.

The camera mounting assembly is packed separately in the same container. The UV

transilluminator and cabinet top are both packed in separate boxes. Make sure you have received

all the hardware before discarding the shipping carton.

1. The largest box will be the DE500 cabinet. This box will include camera bracket, camera

bracket gasket, RS-232 cable, magnetic pad and pen.

2. Set the entire cabinet assembly on a level, flat surface. (There are indentations to the bottom

of the cabinet, please use them for lifting and placement of the unit. The cabinet weighs

80lbs with the UV transilluminator please take appropriate precautions in lifting and moving

the light cabinet.) The footprint dimensions for the cabinet is 20” wide X 14” deep.

3. Open door and remove shipping foam from above and below fold down white light table.

Note: camera bracket, gasket, RS-232 and magnetic pad/pen will be located in and around

the shipping foam. Fold up white light table.

Note: be sure to remove the inserts from the white sidelight bulbs.

4. Slide out UV tray. Unpack UV transilluminator and mount onto sliding tray (be sure to align

UV transilluminator rubber feet into sliding tray open positions). Inside the cabinet, locate

the power cord taped with RED tape. Please uncoil and insert into the power socket for the

UV transilluminator. (Additionally: if installing ChromaLight please use the BLUE taped

power cord for the transilluminator.

5. Plug the light cabinet into the surge protector, turn on the cabinet, and test each of the

switches on the front of the cabinet to ensure that all connections were made properly. Note:

Do not plug a transilluminator or the MultiImage II light cabinet into the same power

strip as the computer; use a different circuit whenever possible.

6. AlphaEaseFC provides cabinet controls through software. An RS-232 cable that is supplied

with the cabinet is required for this purpose. Please located the RS-232 cable insert it into

the corresponding socket next to the power connect and power switch on the rear of the

DE500 (see picture following page).

1 2 ... 198 199 200 201 202 203 204 205 206

No comments

Mitsubishi P91DW User Manual Page 203