Mitsubishi HD-5000A Instruction Manual download pdf (Page 142)

5 - 1

5. PARAMETERS

CAUTION

Never adjust or change the parameter values extremely as it will make operation

instable.

5.1 Parameter list

5.1.1 Parameter write inhibit

POINT

Set "000E" when using the MR Configurator (Servo Configuration

Software) to make device setting.

After setting the parameter No.19 value, switch power off, then on to

make that setting valid.

In the servo amplifier, its parameters are classified into the basic parameters (No.0 to 19), expansion

parameters 1 (No.20 to 53), expansion parameters 2 (No.54 to 77) and special parameters (No.78 to 90)

according to their safety aspects and frequencies of use. In the factory setting condition, the customer can

change the basic parameter values but cannot change the expansion parameter 1,2 values and special

parameter values. When fine adjustment, e.g. gain adjustment, is required, change the parameter No.19

setting to make the expansion parameters write-enabled.

The following table lists the parameters whose values are made valid for reference/write by setting

parameter No. 19. Operation can be performed for the parameters marked

Parameter No.19

setting

Operation

Basic parameters

No.0 to No.19

Expansion parameters 1

No.20 to No.53

Expansion parameters 2

No.54 to No.77

special parameters (No.78 to 90)

Reference 0000

(initial value)

Write

Reference No.19 only

000A

Write No.19 only

Reference

000B

Write

Reference

000C

Write

Reference

000E

Write

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 355 356

Comments to this Manuals

No comments

Mitsubishi HD-5000A Instruction Manual Page 142

Comments to this Manuals