Mitsubishi HD-5000A Instruction Manual download pdf (Page 163)

5 - 22

5. PARAMETERS

5.2.2 Changing the status display screen

The status display item of the servo amplifier display and the display item of the external digital display

(MR-DP60) shown at power-on can be changed by changing the parameter No.18 (status display

selection) settings. In the initial condition, the servo amplifier display shows the servo motor speed and

the MR-DP60 shows the current position.

For display details, refer to section 7.2.

Parameter No. 18

Status display on servo amplifier displa

at power-on

00: Current position (initial value)

01: Command position

02: Command remaining distance

03: Program No.

04: Step No.

05: Cumulative feedback pulses

06: Servo motor speed

07: Droop pulses

08: Override voltage

09: Analog torque limit voltage

0A: Regenerative load ratio

0B: Effective load ratio

0C: Peak load ratio

0D: Instantaneous torque

0E: Within one-revolution position low

0F: Within one-revolution position high

10: ABS counter

11: Load inertia moment ratio

12: Bus voltage

Status display of MR-DP60 at power-on

00: Current position (initial value)

01: Command position

02: Command remaining distance

03: Program No.

04: Step No.

05: Cumulative feedback pulses

06: Servo motor speed

07: Droop pulses

08: Override voltage

09: Analog torque limit voltage

0A: Regenerative load ratio

0B: Effective load ratio

0C: Peak load ratio

0D: Instantaneous torque

0E: Within one-revolution position

0F: ABS counter

10: Load inertia moment ratio

11: Bus voltage

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 355 356

Comments to this Manuals

No comments

Mitsubishi HD-5000A Instruction Manual Page 163

Comments to this Manuals