Mitsubishi HD-5000A Instruction Manual download pdf (Page 37)

1 - 18

1. FUNCTIONS AND CONFIGURATION

(4) MR-J2S-700CL

POINT

The servo amplifier is shown without the front cover. For removal of the

front cover, refer to next page.

MODE

UP DOWN

SET

MODE

DOWN SET

Name/Application

Reference

Battery connector (CON1)

Used to connect the battery for absolute position data

backup.

Section 4.5

Battery holder

Contains the battery for absolute position data backup.

Section 4.5

Display

The 5-digit, seven-segment LED shows the servo

status and alarm number.

Chapter 7

Operation section

Used to perform status display, diagnostic, alarm and

parameter setting operations.

Chapter 7

Used to set data.

Used to change the

display or data in each

mode.

Used to change the

mode.

I/O signal connector (CN1A)

Used to connect digital I/O signals.

Section 3.3

I/O signal connector (CN1B)

Used to connect digital I/O signals.

Section 3.3

Communication connector (CN3)

Used to connect a command device (RS-422/RS-232C)

and output analog monitor data.

Chapter 6

Chapter 15

Section 14.1.4

Charge lamp

Lit to indicate that the main circuit is charged.

While this lamp is lit, do not reconnect the cables.

Control circuit terminal block (TE2)

Used to connect the control circuit power supply.

Encoder connector (CN2)

Used to connect the servo motor encoder.

Rating plate

Main circuit terminal block (TE1)

Used to connect the input power supply, regenerative

option and servo motor.

Protective earth (PE) terminal ( )

Ground terminal.

Section 3.7.2

Section 12.1

Section 3.3

Section 14.1.4

Section 1.4

Section 3.7.2

Section 12.1

Section 14.1.1

Cooling fan

Fixed part

(4 places)

Section 3.10

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 355 356

Comments to this Manuals

No comments

Mitsubishi HD-5000A Instruction Manual Page 37

Comments to this Manuals